Replacing The Minitower Side Covers - NEC POWERMATE ES 5200 Manual

Replacing the Minitower Side Covers

Replace the side covers as follows.
Ensure that all cables are positioned to prevent
kinking, crimping, abrasion, or cutting while
installing the side cover. Check that the ribbon
cables are folded along their fold lines and out of
the direct path of the side cover.
1. Position the side cover over the side of the chassis so that
the back edge of the cover is about an inch beyond the
back edge of the chassis.
2. Fit the flanges on the bottom and side of the cover into
the rails along the side and bottom edges of the chassis.
3. Fit the tabs on the top of the cover into the slots at the top
of the chassis (see the following figure).
Note:
addition to fitting the cover's flanges and tabs in
the chassis, also align the tab on the inside of the
cover with its slot on the back of the chassis.
! CAUTION
For the right side cover only, in
Installing Options 5-15