Installing A 5 1/4-Inch Device - NEC POWERMATE PROFESSIONAL 9000 Service Manual

Installing a 5 1/4-Inch Device

Use the following procedure to install a 5 1/4-inch device into a 5 1/4-inch accessible device
slot.
Follow the preinstallation instructions that come with the device, such as setting
1.
jumpers and switches.
See "Preparing the Device" for device preparation information.
2. Remove both side covers of the system unit (see "Removing the Covers").
3. Remove the front panel (see "Removing the Front Panel").
4. From the front of the system, insert the device, connector end first, into the device
slot.
5. Connect the device cables (see "Connecting Device Cables" and "Cabling Storage
Devices").
Insert the device the rest of the way into the device slot. Secure the device to the
6.
front of the chassis with screws as shown in the following figure.
NOTE: A 3 1/2-inch hard disk drive can also be
installed in a 5 1/4-inch device slot if the device is
fitted into a 5 1/4-inch frame adapter frame first.
NOTE: To easily access device connectors for
cabling, do not insert a 5 1/4-inch device all the
way into the slot.
Option Installation 3-33