Removing The External Scsi Connector Kit - NEC POWERMATE PROFESSIONAL 9000 Service Manual

3-44 Option Installation

Removing the External SCSI Connector Kit

Remove the external SCSI connector kit by following these steps:
Remove the left cover on the system unit (see "Removing the Covers").
1.
2. Remove the drive cage (see "Removing the Drive Cage").
3. Label and disconnect any cable that interferes with the removal of the connector
kit.
4. Disconnect the connector kit from the internal SCSI cable. Terminate the cable.
Remove the screw that secures the connector kit to the support bracket. Set the
5.
screw aside (use it to secure the slot cover after the connector kit is removed).
Pull the connector kit out of the expansion board slot.
6.
7. Replace the slot cover and slot cover screw.
Reconnect the cables that were disconnected to free a path to the connector kit.
8.
Replace the drive cage (see "Replacing the Drive Cage").
9.
10. Replace the cover on the system unit (see "Replacing the Covers").
Figure 3-38 Replacing the Slot Cover