Replacing The Side Covers; Removing The Side Cover - NEC PowerMate Professional 9000E Series Service Manual

Repeat this procedure if the other side cover must also be removed.
To replace the cover, see "Replacing the Side Covers."

Replacing the Side Covers

Replace the covers as follows:
To prevent damage to system cables, carefully tuck the
cables out of the path of the cover.
1. Position the cover against the chassis with its front edge about one-half inch
behind the front of the chassis.
2. Fit the cover into the chassis. Make sure that the tabs along the top, back,
and bottom edges of the cover are aligned with the notches and rails in the
chassis (see the figure on the following page).

Removing the Side Cover

! CAUTION
Disassembly and Reassembly 3-5