Exit Menu; Maintenance Menu - NEC POWERMATE PROFESSIONAL 9000 Service Manual

2-28 Setup and Operation
T
Floppy Check
When set to "Enabled" this field verifies the floppy type during boot up; a setting
of "Disabled" (the default) speeds up the boot.
T
Summary Screen
When set to "Enabled" the POST activity is displayed down the screen as the
system boots. The default setting is "Disabled."
T
Virus Check Reminder
When this field is set to "Daily," "Weekly," or "Monthly," the system displays a
virus check reminder message during boot up on a daily, weekly, or monthly
basis. The default setting is "Disabled."
T
System Backup Reminder
When this field is set to "Daily," "Weekly," or "Monthly," the system displays a
system backup reminder message during bootup on a daily, weekly, or monthly
basis. The default setting is "Disabled."
T
Fixed Disk Boot Sector
When this field is set to "Write Protect" the fixed disk boot sector is write-
protected against viruses. The default is "Normal."

Exit Menu

Selecting "Exit" from the menu bar displays the following exit options.
T
Exit Saving Changes
Choose this option if you wish to save any changes made and exit the Setup
program.
T
Exit Discarding Changes
Choose this option if you wish to exit the program without saving any changes
made.
T
Load Setup Defaults
Choose this option if you wish to load the original system BIOS default settings.

Maintenance Menu

The Maintenance Menu only appears when the system board has been jumpered for
Configure mode. When the system is restarted in Configure mode, the Setup Utility comes
up in the Maintenance Menu. (The Main, Advanced, Power Management, Security, Boot,
and Exit menus are also available when the system is in Configure mode.)
NOTE: The Maintenance Menu only appears
when the computer has been jumpered for
Configure mode.