Wake On Lan Connector - NEC POWERMATE PROFESSIONAL 9000 Service Manual

Wake On LAN Connector

Table A-33 provides the pin assignments for Wake on LAN header J6D1. This header is
used to implement the Wake on LAN feature. Connect the header to a network interface
card (NIC) that supports Wake on LAN technology, such as the Intel LAN Pro 100 NIC
available from NECCSD.
The NIC monitors network traffic. When the NIC detects a Magic Packet, it sends a signal
through the Wake on LAN header to wake up the computer. This signal can wake up the
computer only when the power cord is still plugged into the socket and the computer is
turned off.
Wake on LAN can be enabled through the BIOS Setup utility (see Section 2).
Table A-32 Hard Drive LED Input
Header (J11B1)
Signal Name
Pin
1 Ground
2 DRV_ACT#
3 DRV_ACT#
4 Ground
Table A-33 Wake on LAN Header (J6D1)
Pin Signal Name
1 +5 VSB
2 Ground
3 MP_WAKEUP
NOTE: The computer's power supply must
provide sufficient +5 VSB current to the NIC;
without enough +5 VSB current, the Wake on
LAN feature will not function and the system
board may not boot. Check the NIC's
documentation for its +5 VSB current
requirements.
Connector Pin Assignments A-23