Using The Nec Select Install Cd With A Scsi Drive; Using The Selective Application Restore Program On A Remote Cd - NEC POWERMATE PROFESSIONAL 9000 Service Manual

2-68 Setup and Operation
6. Click .
OK
The software files reload sequentially, and a progress bar appears for each
application or driver selected.
When all the optional software components have finished installing, remove the
7.
CD.
Click
8.
Restart Computer
completes successfully.

Using the NEC Select Install CD with a SCSI Drive

If a situation arises in SCSI configurations where a full operating system restore must be
performed using the NEC Select Install CD, first boot the system from the bootable
diskette. (This might be necessary, for example, if the system does not boot from the hard
disk drive.) The bootable diskette comes with all systems that have a SCSI hard disk drive.
After the system boots, proceed with the NEC Select Install procedure described above.

Using the Selective Application Restore Program on a Remote CD

If the computer is connected to a network and set up to access a shared CD-ROM reader, a
System Administrator can install the applications associated with the OS from the NEC
Select Install CD in the remote CD-ROM reader. Use this process to reinstall selected
applications, or to install optional software.
1. In Windows 95 systems only, set up the system for sharing files as follows. On
Windows NT systems, go to step 2.
T
Press the
Control Panel
T
Double click the
T
Double click the
T
Click the
T
Click the top box ("I want to give other access to my files") so a check mark
appears.
T
Click
OK
to reboot and ensure that the installation process
NOTE: The following procedure applies for
both Windows 95 and Windows NT systems.
Differences in the procedure for each OS are
noted as they occur.
button, scroll up and select
Start
from the submenu.
Control Panel
icon.
Network
File and Print Sharing
. The driver installs and the system reboots.
, then highlight and select
Settings
icon on the Windows 95 desktop.
button.