Intermec EasyCoder PF4i User Manual page 80

Chapter 7—Setup Mode
The Setup Mode is organized as an endless loop, from which you can
select a number of sub-categories. At startup, the fi rmware determines
if options such as a label taken sensor, a cutter, or an interface board is
installed in the printer. Only installed options are shown in the Setup
Mode.
The diagram below shows the options in the main loop. Detailed over-
views are shown on the pages that follow.
SETUP:
SER-COM, UART1
SETUP:
PRINT DEFS
SETUP:
MEDIA
SETUP:
FEEDADJ
66
Starting point
Intermec EasyCoder PF4i—User's Guide (Fingerprint version)
SETUP:
SER-COM, UART2
Option
SETUP:
SER-COM, UART3
SETUP:
NET-COM, NET1
SETUP:
NETWORK
Option
Option
Option