Entering The Setup Mode At Installation - Intermec EasyCoder PF4i User Manual

Chapter 7—Setup Mode
Entering Setup Mode at Installation
The method of entering the Setup Mode depends on which startup fi les
are stored in the printer's memory, a subject that was more thoroughly
discussed in Chapter 3, "Starting Up."
EasyCoder PF4i with Intermec Shell
• Switch on the power.
• When the display shows the message "Enter=Shell; x sec...", press
<Enter>.
• Press <Setup> (this facility can be used anywhere within Intermec
Shell).
• Set up the printer as described in this chapter.
• Return to Intermec Shell by pressing <Setup>.
EasyCoder PF4i with a custom-made application program
• Normally, there is no need to enter the Setup Mode for custom-made
application programs. Necessary provisions for changing the setup,
manually or automatically, should be provided by the program.
64 Intermec EasyCoder PF4i—User's Guide (Fingerprint version)