Express-VR7 User's Guide
3. Assemble the heatsink onto the COM Express module. Use the 3x M2.5, L=6mm screws provided to fasten the heatsink to the module. The
number of screw holes and screws are module dependent, picture below is for illustration only
4. Place the COM Express module and heatsink assembly onto the connectors on the carrier board as exemplified below.
Then press down on the module until it is firmly seated on the carrier board.
Page 75
Copyright © 2024 ADLINK Technology, Inc.
PICMG COM.0 R3.1
Need help?
Do you have a question about the AMD COM Express Express-VR7 and is the answer not in the manual?