CENTURION SYSTEMS D2 Turbo Installation Manual page 79

Step 4: Return the Function Dial to
the RUN position.
Please note that PIRAC
Mode can be active in
addition to this mode if so
desired.
Setting PIRAC Mode
PIRAC (Beam Autoclose) Mode can
be activated when using any of the
three Operating Modes (Standard,
Open Only, or Reversing).
To select PIRAC Mode as either On or
Off, please follow the steps below:
Step 1: Rotate the Function Dial to
the MODE position (D).
Step 2: Rotate the Setting Dial to the
PIRAC on/off selection along the 'D'
row of options.
Step 3: Press the pushbutton to
select the setting.
The Status LED will change from red
to green indicating that PIRAC Mode
has been activated, or it will change
to red indicating that PIRAC Mode
has been deactivated.
www.CentSys.com page 79
FIGURE 125
FIGURE 126
FIGURE 127