Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 72

Installing Cisco Interface Cards in 1- or 2-Slot Network Modules
Initiate a network module console session with the following command:
Step 9
Router# service-module service-engine slot / port session
Trying 10.10.10.1, 2129 ... Open
SE-netmodule con now available
Press RETURN to get started!
SE-netmodule> enable
SE-netmodule#
Restore the running configuration for the network module with the following command from the
Step 10
SE-netmodule prompt:
SE-netmodule# copy ftp: running-config
Address or name or remote host? username / password / remote host
Source filename? filename
Exit the network module console session by pressing Ctrl-Shift-6, followed by x.
Step 11
On the router, clear the console session using the following command:
Step 12
Router# service-module service-engine slot / port session clear
Installing Cisco Interface Cards in 1- or 2-Slot Network Modules
Some network modules have one or two interface card slots, which support a variety of voice and data
interface cards. (See
Do not install an ISDN BRI WAN interface card or an ISDN BRI network module in the same chassis
Note
as an ISDN PRI network module unless you are using Cisco IOS Release 11.3(3)T or later.
Do not install newer BRI WAN interface cards in the same network module as older BRI WAN interface
Note
cards. To identify newer BRI WAN interface cards, examine the B-channel LEDs. Newer BRI WAN
interface cards have B-channel LEDs that are arranged horizontally. Older BRI WAN interface cards
have B-channel LEDs that are arranged vertically.
To install an interface card in a 1- or 2-slot network module, perform the following steps:
Turn off electrical power to the router. Leave the power cable plugged in to channel ESD voltages to
Step 1
ground.
The following warning applies to routers that use a DC power supply:
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit.
To ensure that all power is OFF, locate the circuit breaker on the panel board that services the DC
circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the circuit
breaker in the OFF position. Statement 7
Cisco Network Modules Hardware Installation Guide
2-24
Chapter 2
Table 1-2 on page 1-8 for more information.)
Installing Cisco Network Modules in Cisco Access Routers
OL-2485-20