Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 289

Chapter 26 Connecting NAM Enhanced Network Modules
Trying 10.10.10.1, 2129 ... Open
Restore the network module running configuration by using the following command from the service
Step 15
module prompt:
root@nam.localdomain# config network ftp:// username @ host / path / filename
Exit the network module session by pressing Control-Shift-6, followed by x.
Step 16
On the router, clear the network module session by using the following command:
Step 17
Router# service-module integrated-service-engine slot / unit session clear
Additional References
For additional information, see the following documents and resources.
Related Topic
NAM software installation and
administration, configuration, and
operation
Cisco IOS software website and reference
documentation
Technical documentation, including
feedback and assistance
OL-2485-20
Document Title
Cisco Branch Router Series (NME-NAM) Installation and
Configuration Note at
http://www.cisco.com/en/US/products/sw/cscowork/ps5401/products_installati
on_and_configuration_guide09186a00807ee90a.html
Cisco IOS Software at
http://www.cisco.com/en/US/products/sw/iosswrel/tsd_products_support_cate
gory_home.html
What's New in Cisco Product Documentation (including monthly listings of new
and revised documents) at
http://www.cisco.com/univercd/cc/td/doc/abtunicd/136957.htm
Cisco Network Modules Hardware Installation Guide
Additional References
26-5