Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 219

Chapter 17 Connecting Ethernet Switch Network Modules
When using the NM-16ESW network module with the MWR 1941-DC router, shielded cables are
Note
required, and IP phone inline power is not supported.
Restrictions for Cisco 3700 Series Routers
Cisco 3700 series routers contain internal –48-V power supplies to supply power to the Ethernet switch
network module.
For the Cisco 3745 router, the following specifications apply:
•
•
•
Cisco 3725 routers have a single –48-V supply. Cisco 3725 routers do not report any power supply
status. The only software indication of –48-V status is the –48-V status bit provided on the 16-port
Ethernet switch network module board.
Restrictions for Cisco 2600 Series and Cisco 3600 Series Routers
Cisco 2600 series and Cisco 3600 series routers do not supply –48-V power, so an external –48-V supply
is required to support inline power for IP phones. This external power supply connects to the Ethernet
switch network module faceplate with a cable.
An external power supply plugged into an Ethernet switch network module provides power only for that
specific network module. To supply redundant power, a Y cable can be used so that two external power
supplies are connected to the same card.
For more information about external power supplies, see the
Ethernet Switch Network Modules Installation
OL-2485-20
The Cisco 3745 router can have one or two internal –48-V power supplies. The internal supplies of
the Cisco 3745 router are configured to be redundant by default.
With a single power supply, the Cisco 3745 router can provide up to 360 W. This is enough power
for up to 36 10-W IP phones. With two nonredundant power supplies, 640 W can be provided,
supporting up to 64 10-W IP phones.
The Cisco 3745 router main board has four independent signals to indicate status on both internal
power supplies. Changes on the state of any of these four signals interrupts the main processor on
the Cisco 3745 router so software can take the appropriate action.
Cisco External Power Supply for Cisco
Guide.
Cisco Network Modules Hardware Installation Guide
Power Considerations
17-3