Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 68

Removing or Replacing Cisco Network Modules for Cisco Access Routers
Install the appropriate item.
Step 5
•
•
See the
Tip
documentation.
Removing or Replacing Double-Wide and Extended Double-Wide Network
Modules in Cisco Access Routers
To remove or replace a double-wide or extended double-wide network module, perform these steps:
Turn off electrical power to the router. Leave the power cable plugged in to channel ESD voltages to
Step 1
ground.
Unplug all network interface cables from the network module.
Step 2
To make it easier to work with network cables, label the cables or prepare a network cabling diagram
Timesaver
before removing network interface cables from the network module.
Using your thumbs, open the levers on the network module faceplate. (See
Step 3
ejector levers open, they unseat the network module from the router. The network module faceplate
moves away from the router rear panel.
Figure 2-15 Removing Double-Wide and Extended Double-Wide Network Modules from Cisco Access
Using your fingers, grasp the edges of the network module faceplate, near the bottom where the board
Step 4
attaches. Pull the network module from the router slot.
Cisco Network Modules Hardware Installation Guide
2-20
(If you are replacing the module) Install a replacement module using the procedures described in the
"Installing Cisco Network Modules in Cisco Access Routers" section on page 2-5
(If you are not replacing the module) Install a blank faceplate over the empty slots to ensure proper
airflow. (See the "Installing and Removing Blank Faceplates" section on page
"Where to Go Next" section on page 2-27
Routers
S
L
O
T
X
A= FD 3
A= LI NK A
T
A= AC
0/ 0
EE D G E
S= SP F
0/ 1 S
G E S
L
O
L
A
T
1
F
S 0
AI M
M 1
0 AI
L
PV DM
DM 1
2 PV
PV DM
Chapter 2 Installing Cisco Network Modules in Cisco Access Routers
for information on locating additional hardware
T
D
M
0
S
L
O
T
2
S
L
O
T
0
2-6.)
Figure 2-15.) When the
OL-2485-20