Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 28

Cabling for Cisco Network Modules
Table 1-3 Cabling for Cisco Network Modules (continued)
Connector Type,
Connection Type Cable Color
Service Module Connections
To external storage 68-pin D
array
Token Ring Connections
Token Ring, shielded DB-9
Token Ring, RJ-45
unshielded
WAN Connections
T1/E1 WAN RJ-48C/CA81A
T3/DS3/E3 WAN BNC connector
Wireless and Satellite Connections
To antenna BNC
To satellite dish F-connector
Voice Connections
Analog voice RJ-21
FXS/FXO
A single fiber link should not mix 62.5- and 50-micron cable.
Note
Table 1-4
Interface
EIA/TIA-232
EIA/TIA-449
Cisco Network Modules Hardware Installation Guide
1-14
Cable
68-pin low-voltage differential (LVD) SCSI
36-, 91- or 108-inch (274 cm) cables
Note
can be used, depending on the
distance between the network module
and the external storage array.
Token Ring lobe cable, shielded STP
Token Ring lobe cable, unshielded UTP
RJ-48 T1/E1 straight-through
BNC T3/E3 coaxial
BNC indoor IF coaxial
75-ohm F-connector shielded RG-6
253PP10GYADI male-to-male (Graybar)
253PC10GYADI male-to-female (Graybar)
AT125-SM patch panel (Graybar)
RJ-21 cable
Cisco 12-in-1 Smart Serial Interface Cable Part Numbers
DCE/DTE
Female DCE
Male DTE
Female DCE
Male DTE
Chapter 1 Overview of Cisco Network Modules for Cisco Access Routers
Cisco Cable Part Number
CAB-SS-232FC
CAB-SS-232MT
CAB-SS-449FC
CAB-SS-449MT
Use with
NM-CE-BP-SCSI
NM-1E1R2W
NM-1FE1R2W
NM-1FE1R2W-V2
NM-4T1-IMA
NM-8T1-IMA
NM-4E1-IMA
NM-8E1-IMA
NM-HDV2-1T1/E1
NM-HDV2-2T1/E1
NM-1T3/E3
NM-1A-T3
NM-1A-E3
NM-1A-T3/E3
NM-WMDA
NM-1VSAT-GILAT
NM-HDA-4FXS
EVM-HDA-8FXS/DID
OL-2485-20