Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 207

Chapter 15 Connecting Wireless Multipoint Network Modules
Figure 15-3 Components of the Multipoint Subscriber-Unit System
Note The antenna, wireless transverter, and power injector are third-party products. For further
information about these components, see the manufacturer's documentation.
Hardware and Software Requirements
Wireless multipoint network modules require that the router have at least 16 MB of flash memory.
The wireless multipoint network modules require an external microcode bundle. You can download this
microcode at http://www.cisco.com/cgi-bin/tablebuild.pl/rsu.
Connecting Wireless Ports to the Network
Use an indoor IF coaxial cable to connect the wireless network module Main connector to a power
injector. If you are using the diversity feature, connect the network module Diversity connector to a
second power injector.
Wireless Multipoint Network Module LEDs
Wireless multipoint network modules have the LEDs shown in
Table 15-1 Wireless Multipoint Network Module LEDs
LED
EN (Enable)
RECEIVE DATA
SEND DATA
OL-2485-20
Meaning
The module has passed its self-tests and is available to the router.
The module is receiving packets.
The module is sending packets.
Cisco Network Modules Hardware Installation Guide
Hardware and Software Requirements
Table 15-1.
15-3