Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 410

How to Install, Connect, or Replace the EVM-IPVS-16A Network Module
Restrictions
•
•
•
Steps
To perform OIR of the EVM-IPVS-16A network module in your router, follow these steps:
Step 1 Initiate a console session with your router.
Enter configuration mode and shut down the interface:
Step 2
Router> enable
Router# configure terminal
Router(config)# interface video-Service-Engine
Router(config-if)# shut
Router(config-if)# shutdown
Router(config-if)# exit
Disconnect the terminal block connector cables from the terminal blocks on the EVM-IPVS-16A
Step 3
network module.
Hazardous voltages may be present in the outdoor camera cables under fault conditions. Disconnect
Warning
all cables from the outdoor cameras before servicing this equipment. Statement 376
Disconnect the DB-37 to BNC video breakout cable from the VIDEO connector on the EVM-IPVS-16A
Step 4
network module.
Using a number 1 Phillips or flat-blade screwdriver, loosen the captive mounting screws on the network
Step 5
module faceplate.
To avoid damaging the network module, always handle the network module by the handle or faceplate.
Caution
Do not touch the circuit board.
Step 6 Using the module handle, pull the network module from the router slot. (See
Figure 39-7
ETHE RNET 0
Cisco Network Modules Hardware Installation Guide
39-10
Only the Cisco 3845 router supports OIR of the EVM-IPVS-16A network module.
All connections made through the EVM-IPVS-16A network module are reset during OIR.
You must perform OIR with similar modules. If you remove a network module, install another
network module exactly like it in its place.
Removing a Network Module
WO
SERIA L
EVM
IPVS- 16A
20
11
3210
1
Chapter 39 Connecting Cisco Analog Video Gateway Network Modules
slot
/0
Figure 39-7.)
OL-2485-20