Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 305

Chapter 28 Connecting Cisco High-Density Extension Modules
Figure 28-2 Installing an Expansion Module on Extension Module Slot EM1
N M
E V -
H D
M -
A H D
V
8 F
X S
E M /D ID
0
N o
n e
E M
1
N o
n e
1 Expansion module connector on the network
module (for slot EM1).
Using a small flat-blade screwdriver, tighten the screws to secure the expansion module to the network
Step 5
module.
Warning Failure to secure the expansion module to the base module with two screws defeats the earth ground,
causing a potential safety hazard. Statement 347
To maintain proper seating of the network module, tighten the rear screw first.
Tip
Step 6 Apply the appropriate label on the front of the network module faceplate. (See
OL-2485-20
2 6
1
5 0
2 5
A C
T
E N
Installing Expansion Modules on Cisco High-Density Extension Modules
2
1
2 Screw bracket on the network module
faceplate (for slot EM1).
Cisco Network Modules Hardware Installation Guide
Figure 28-3.)
28-5