Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 205

Connecting Wireless Multipoint Network
Modules
This chapter explains how to connect the wireless multipoint network module and contains the following
sections:
•
•
•
•
•
•
To determine whether your router supports a specific network module, see
Tip
Wireless Multipoint Network Modules
The wireless multipoint network module, shown in
(SU), provides a high-speed broadband fixed wireless radio-frequency (RF) link between each
subscriber site and a single headend site. This link delivers full-duplex data in the licensed MMDS band
(2.500 to 2.690 GHz) or unlicensed U-NII band (5.725 to 5.825 GHz).
The headend of the system consists of a Cisco uBR7200 series universal broadband router, one or more
wireless modem cards, and the required subsystem for each modem card. The diversity option, which
minimizes the effects of fading, uses two wireless transverters at each site, with each transverter
connected to its own antenna. (See
Figure 15-1 Wireless Multipoint Network Module with Diversity
NM-WMDA
OL-2485-20
Wireless Multipoint Network Modules, page 15-1
Subscriber-Unit System, page 15-2
Hardware and Software Requirements, page 15-3
Connecting Wireless Ports to the Network, page 15-3
Wireless Multipoint Network Module LEDs, page 15-3
Related Documents, page 15-4
DIVERSITY
C H A P T E R
Figure 15-1, also referred to as a subscriber unit
Figure 15-2.)
MAIN
Cisco Network Modules Hardware Installation Guide
15
Table 1-6 on page
EN
1-16.
15-1