Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 356

How to Install, Connect, or Replace the NM-1VSAT-GILAT Network Module
Figure 33-5
1
2
What to Do Next
Proceed to the
section on page
Connecting the NM-1VSAT-GILAT Network Module to the External
Power Supply
This section describes how to connect the NM-1VSAT-GILAT network module to the external
power supply that comes in the "Sat Kit" provided by a Gilat SkyEdge satellite service provider. The
NM-1VSAT-GILAT network module requires additional power to operate the ODU, which includes the
dish antenna and its parts, such as the LNB, SSPA, OMT, and feed horn.
If an installation technician has already connected a power supply to the ODU, then do not perform
Note
this task. Instead, proceed directly to the software configuration tasks for your NM-1VSAT-GILAT
network module. See the
Cisco IOS feature module.
Cisco Network Modules Hardware Installation Guide
33-12
Connecting the NM-1VSAT-GILAT Network Module to the ODU
ODU
1
2
LNB
SSPA
"Connecting the NM-1VSAT-GILAT Network Module to the External Power Supply"
33-12.
Cisco IP VSAT Satellite WAN Network Module (NM-1VSAT-GILAT)
Chapter 33 Connecting Cisco IP VSAT Satellite WAN Network Modules
3
NM-1VSAT
GILAT
RF-IN
EXT RE
LOCK SYNC
DC
3
RF-IN connector
4 RF-OUT connector
IDU
4
ODU PWR
RF-OUT
ON
TX EN
LINE
OL-2485-20