Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 378

Online Insertion and Removal of NME-APA-E3
Confirm that the NME-APA has shut down by using the following command (Shutdown takes several
Step 8
minutes):
Router# service-module integrated-service-engine slot / unit status
Service Module is Cisco Integrated-Service-Engine1/0
Service Module supports session via TTY line 66
Service Module is Shutdown
Service Module status is not available
Note Before the module shuts down, the returned text reads "Service Module is being Shutdown." When the
module has completely shut down, the returned text reads "Service Module is Shutdown"
Step 9 Do not Exit from the router telnet session.
the session.
Replacing the NME-APA
To physically remove the old module and replace it with a new one, follow these steps.
If you have not previously performed the
Step 1
page
•
Unplug all network interface cables from the network module.
Step 2
Loosen the two captive screws holding the network module in the chassis slot.
Step 3
Slide the network module out of the slot.
Step 4
Step 5 Align the replacement network module with the guides in the chassis slot, and slide it gently into the slot.
Note
Push the module into place until you feel its edge connector mate securely with the connector on the
Step 6
backplane. Tighten the captive screws that secure the module in the slot.
Reconnect the network interface cables that you removed in
Step 7
•
Check that the network module LEDs are on and that the power (PWR) and enable (EN) LEDs on the
Step 8
front panel are also on. This inspection ensures that connections are secure and that the new unit is
operational.
Cisco Network Modules Hardware Installation Guide
35-6
Chapter 35
35-4, perform the procedure now.
If you are replacing an NME-APA-E3 in a Cisco 3845 ISR continue to
an NME-APA-E2, remove power from the router before you continue directly to
If the router is not fully configured with network modules, make sure that blank panels are
installed on the unoccupied chassis slots to provide proper airflow.
If you are replacing an NME-APA-E3 in a 3845 ISR continue to
NME-APA-E2, power up the router before continuing to the next step.
Connecting Application Performance Assurance Enhanced Network Modules
Replacing the NME-APA
"Saving the NME-APA Configuration File" procedure on
Step 2.
assumes that you have not exited
Step 2. If you are replacing
Step 2.
Step 8. If you are replacing an