Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 52

Recommended Practices for Cisco Network Modules
Warning This equipment is to be installed and maintained by service personnel only as defined by AS/NZS
3260 Clause 1.2.14.3 Service Personnel. Statement 88
This equipment will be inoperable when mains power fails. Statement 198
Warning
Incorrect connection of this or connected equipment to a general purpose outlet could result in a
Warning
hazardous situation. Statement 212
Warning Because invisible laser radiation may be emitted from the aperture of the port when no fiber cable
is connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 125
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to
Warning
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports
contain TNV circuits. Both LAN and WAN ports may use RJ-45 connectors. Use caution when
connecting cables. Statement 1021
Warning Hazardous network voltages are present in WAN ports regardless of whether power to the router
is OFF or ON. To avoid electric shock, use caution when working near WAN ports. When detaching
cables, detach the end away from the router first. Statement 1026
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Before opening the chassis, disconnect the telephone-network cables to avoid contact with
Warning
telephone-network voltages. Statement 1041
Warning The telecommunications lines must be disconnected 1) before unplugging the main power
connector and/or 2) while the housing is open. Statement 1043
Cisco Network Modules Hardware Installation Guide
2-4
Chapter 2 Installing Cisco Network Modules in Cisco Access Routers
OL-2485-20