Summary Of Installation Tasks - Cisco CISCO2650 - 2650 Router Hardware Installation Manual

Installing Cisco Network Modules in Cisco Access Routers

Summary of Installation Tasks

When installing a network module in a Cisco access router, perform the following tasks:
Table 2-1 Network Module Hardware Installation Tasks for Cisco Access Routers
For Cisco 2600 Series, Cisco 2811, Cisco 3600 Series
(Except Cisco 3660 Routers), and Cisco MWR 1941-DC
Routers
Step 1 Turn off power to the router.
Step 2 Remove blank faceplates from the slots you plan to use.
(See the "Removing Blank Faceplates from Cisco Access
Routers" section on page
Step 3
Install the network module. (See the
Single-Wide, Extended Single-Wide, and Extension
Voice Network Modules in Cisco Access Routers"
"Installing Double-Wide and Extended Double-Wide
Network Modules in Cisco Access Routers"
Step 4 Install blank faceplates where appropriate. (See the
"Installing Blank Faceplates on Cisco Access Routers"
section on page 2-7.)
Step 5
—
Installing and Removing Blank Faceplates
All empty chassis slots for network modules, extension voice modules, or interface cards must be
covered with blank faceplates to ensure proper cooling airflow and to prevent electromagnetic
interference.
Note Blank network module faceplates are for single-wide network module slots only.
To install a blank faceplate over a network module slot set up for an extended single-wide, double-wide,
or extended double-wide network module, you must prepare the slot for single-wide network modules.
See
module form factors.
Cisco Network Modules Hardware Installation Guide
2-6
2-8.)
"Installing
Table 2-3 and Table 2-4 for information on preparing network module slots for different network
Chapter 2 Installing Cisco Network Modules in Cisco Access Routers
For Cisco 2821, Cisco 2851, Cisco 3700 Series, Cisco 3800
Series, and Cisco 3660 Routers
Turn off power to the router.
Remove blank faceplates from the slots you plan to use.
(See the "Removing Blank Faceplates from Cisco Access
Routers" section on page
Prepare the slot for the network module form factor you
are installing. (See the
and Network Module Installation" section on page
sections.)
Install the network module. (See the
Single-Wide, Extended Single-Wide, and Extension
Voice Network Modules in Cisco Access Routers"
section on page 2-15
Extended Double-Wide Network Modules in
Cisco Access Routers" section on page 2-16
Install blank faceplates where appropriate. (See the
"Installing Blank Faceplates on Cisco Access Routers"
section on page
2-8.)
"Preparing Cisco Router Slots for
"Installing
and "Installing Double-Wide and
2-7.)
2-8.)
sections.)
OL-2485-20