Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 380

Online Insertion and Removal of NME-APA-E3
Confirming the Startup Configuration (Optional)
To confirm that the startup configuration file was restored properly, you can use a reload command on
the module.
Telnet to the NME-APA's router:
Step 1
Router# telnet 10.10.10.1
Trying 10.10.10.1, 2065 ... Open
Press RETURN to get started!
router> enable
router#
Reload the NME-APA:
Step 2
Router# service-module integrated-service-engine slot / unit reload
Do you want to proceed with reload?[confirm]
Trying to reload Service Module Integrated-Service-Engine1/0.
Step 3 After several minutes check the module status and logout:
router# service-module integrated-Service-Engine slot / unit status
Service Module is Cisco Integrated-Service-Engine1/0
Service Module supports session via TTY line 66
Service Module is in Steady state
Getting status from the Service Module, please wait..
Network Module Enhanced - Application Performance Assurance 0.1.2.1
NME-APA running on BRYCE
router# logout
Connection to 172.29.52.241 closed by foreign host.
After a few minutes, telnet to the NME-APA.
Step 4
Note
Router# telnet 10.10.10.1
Trying 10.10.10.1...
Connected to 10.10.10.1.
Escape character is '^]'.
User Access Verification
Username:
Password:
NME-APA> enable
Password:
NME-APA#
Check the running configuration and confirm that it is correct:
Step 5
NME-APA# show running-config
#This is a general configuration file (running-config).
Cisco Network Modules Hardware Installation Guide
35-8
Chapter 35
The module will not accept a telnet session until it has restarted the application which may take
several minutes.
Connecting Application Performance Assurance Enhanced Network Modules