Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 392

Cisco Unified Messaging Gateway Enhanced Network Modules
The Gigabit Ethernet port and compact flash (CF) slot, though available on the hardware, are not
Note
supported by the Cisco Unified Messaging Gateway enhanced network module. The CF slot has a metal
cover.
The Cisco Unified Messaging Gateway enhanced network module LEDs are shown in
described in
Figure 37-1 NME-UMG Faceplate
SHUTDOWN:
GRACEFUL <1 s
IMMEDIATE >4 s
CF
Table 37-1 NME-UMG LED Descriptions
SHUTDOWN
DISK
SYS
EN
Cisco Network Modules Hardware Installation Guide
37-2
Chapter 37
Table 37-1.
NME-UMG
XXX-XXXXX-XX XX
Never remove compact
flash during operation
LINK
Shutdown
Press the SHUTDOWN button for less than 2 seconds to gracefully shut down the
module. Press the SHUTDOWN button for more than 4 seconds to cause an immediate
module shutdown, which may impact file operations that are in progress.
Status of hard drive activity:
On—Active.
Off—Inactive.
Status of system shutdown
Do not remove power without first shutting down the application.
Note
On—Application is stable.
Off—System is shut down and ready for host power-down.
Flashing—System shutdown is in progress.
Status of the network module:
On—Detected by the host Cisco IOS software and enabled.
Off—Disabled.
Connecting Cisco Unified Messaging Gateway Enhanced Network Modules
ACT
DISK SYS
USB
GigE
DISK
SYS
Figure 37-1
Shut down
application
before removing or
power cycling.
NOT
EN
SUPPORTED
EN
OL-2485-20
and