Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 64

Installing Cisco Network Modules in Cisco Access Routers
Figure 2-10 Installing Single-Wide and Extended Single-Wide Network Modules in Cisco Access
ETHE RNET 0
1
Using the network module handle, push the module into place until you feel the edge connector seat
Step 6
securely into the connector on the router backplane. The network module faceplate should contact the
chassis rear panel.
Using a number 1 Phillips or flat-blade screwdriver, tighten the captive mounting screws on the module
Step 7
faceplate.
Proceed with connecting the network module to the network and power up the router.
Step 8
See the
Tip
documentation.
After wiring the DC power supply, remove the tape from the circuit breaker switch handle and
Warning
reinstate power by moving the handle of the circuit breaker to the ON position. Statement 8
Installing Double-Wide and Extended Double-Wide Network Modules in
Cisco Access Routers
Network modules can be installed either before or after mounting the router, whichever is more
convenient. To install a double-wide or extended double-wide network module, perform these steps:
Turn off electrical power to the router. Leave the power cable plugged in to channel ESD voltages to
Step 1
ground.
Remove all network cables, including telephone cables, from the rear panel of the router.
Step 2
Remove the blank faceplates installed over the slot you intend to use. (See the
Step 3
Blank Faceplates" section on page
Save blank faceplates for future use.
Tip
Cisco Network Modules Hardware Installation Guide
2-16
Routers
WO
SERIA L
ASY NC
15
11
ASYN C 24-31
14
10
13
9
12
8
15
11
ASYN C 8-15
14
10
13
9
12
8
Single-wide network module
"Where to Go Next" section on page 2-27
Chapter 2 Installing Cisco Network Modules in Cisco Access Routers
7
3
ASYN C 16-23
6
2
5
1
4
0
7
3
ASYN C 0-7
6
2
5
1
4
0 EN
1
2 Router chassis
for information on locating additional hardware
2-6.)
2
"Installing and Removing
OL-2485-20