Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 164

Adding 6-Port MICA Modules to a Digital Modem Network Module
Removing 6-Port MICA Modules
To remove a MICA module from the digital modem network module, follow these steps:
Orient the digital modem network module so that the faceplate is on the right.
Step 1
Handle MICA modules by the card edges only. MICA modules are ESD-sensitive components and
Caution
can be damaged by mishandling.
Step 2 Remove one MICA module at a time, beginning with the one farthest from you.
To lift the MICA module out of its socket, pull the spring clips on both sides outward (see
Step 3
and tilt the MICA module away from you until it is free of the clips (see
Hold the MICA module by the edges with your thumb and index finger and lift it out of the socket (see
Step 4
Figure
Repeat
Step 5
Cisco Network Modules Hardware Installation Guide
9-6
9-6). Place the removed MICA module in an antistatic bag to protect it from ESD damage.
Step 2 through Step 4 for any remaining MICA modules that you want to remove.
Chapter 9 Connecting Digital Modem Network Modules
Figure 9-5).
Figure 9-4)
OL-2485-20