Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 335

Chapter 31 Connecting Cisco Wireless LAN Controller Modules
Configuring the Replacement WLAN Controller Module
Follow these steps to configure the replacement Cisco WLAN controller module.
Reset the WLAN controller module:
Step 1
Router# service-module wlan-controller 1/0 reset
Use reset only to recover from shutdown or failed state
Warning: May lose data on the hard disc!
Do you want to reset?[confirm]
Trying to reset Service Module wlan-controller1/0.
Turn on the WLAN controller interface, if it is necessary for further configuration:
Step 2
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# interface wlan-controller 1/0
Router(config-if)# ip address 192.0.2.254 255.255.255.0
Router(config-if)# no shutdown
Router(config-if)# end
Router#
Router#
Initiate a WLAN controller module console access session and access the bootloader prompt using the
Step 3
following command:
Note
Router# service-module wlan-controller slot / unit session
Trying 192.0.2.254, 2066 ... Open
Booting Primary Image...
Press <ESC> now for additional boot options...
Detecting hardware . . . .
Cisco is a trademark of Cisco Systems, Inc.
Software Copyright Cisco Systems, Inc. All rights reserved.
Cisco AireOS Version 3.2.10.0
Initializing OS Services: ok
Initializing Serial Services: ok
Initializing Network Services: ok
...
Web Server: ok
CLI: ok
Secure Web: ok
(WLAN-Controller)
Enter User Name (or 'Recover-Config' to reset configuration to factory defaults)
OL-2485-20
The following typical example assumes there is already a configuration image available on the
WLAN controller module CompactFlash memory card. To configure a WLAN controller module
without an available configuration image, see the Cisco Wireless LAN Solution Product Guide
at the following URL:
http://www.cisco.com/en/US/products/ps6305/products_configuration_guide_book09186a008
04f988b.html
Cisco Bootloader (Version 3.2.10.0)
Online Insertion and Removal with a Cisco Wireless LAN Controller Module
End with CNTL/Z.
Cisco Network Modules Hardware Installation Guide
31-5