Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 414

Cisco Video Management and Storage System Enhanced Network Modules
The Cisco Video Management and Storage System enhanced network module LEDs are shown in
Figure 40-1
Figure 40-1 NME-VMSS Faceplate
SHUTDOWN:
GRACEFUL <1 s
IMMEDIATE >4 s
CF
CF
Table 40-2 NME-VMSS LED Description
CF
SHUTDOWN
LINK
ACT
DISK
SYS
EN
Cisco Network Modules Hardware Installation Guide
40-2
Chapter 40
and described in Table
NME-VMSS-HP32
XXX-XXXXX-XX XX
Never remove compact
flash during operation
LINK
CF card LINK
Shutdown
Status of the Compact Flash
Off—Compact Flash is not used
Flashing—Application detected Compact Flash at boot up
Press the SHUTDOWN button for less than 2 seconds to gracefully shut down the
module. Press the SHUTDOWN button for more than 4 seconds to cause an immediate
module shutdown, which may affect file operations that are in progress.
Status of Gigabit Ethernet link
On—Link is enabled
Off—Link is disabled
Status of Gigabit Ethernet activity
On—Active
Off—Inactive
Status of hard drive activity
On—Active
Off—Inactive
Status of system shutdown
Note Do not remove power without first shutting down the application.
On—Application is stable.
Off—System is shut down and ready for host power-down
Flashing—System shutdown is in progress
Status of the network module
On—Detected by the host Cisco IOS software and enabled.
Off—Disabled.
Cisco Video Management and Storage System Enhanced Network Modules
40-2.
ACT
DISK SYS
GigE
ACT DISK
SYS
Shut down
application
before removing or
power cycling.
NOT
EN
SUPPORTED
USB
EN
OL-2485-20