Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 260

Gigabit Ethernet Network Module LEDs
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Connecting Gigabit Ethernet Network Modules to the Network
Warning Because invisible laser radiation may be emitted from the aperture of the port when no fiber cable
is connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 240
Use the cables listed in
networking device. (See
Figure 21-4 Connecting a Gigabit Ethernet Network Module to a Cisco 7200 Series Router
Gigabit Ethernet Network Module LEDs
All network modules have an enable (EN) LED. This LED indicates that the module has passed its
self-tests and is available to the router. See
Ethernet network module.
Cisco Network Modules Hardware Installation Guide
21-4
Table 21-1 to connect the GBIC connectors on the network module to a
Figure 21-4.)
Cisco 7200
Series
NM-1GE
GBIC
Figure 21-5
Chapter 21 Connecting Gigabit Ethernet Network Modules
ETHERNET-10BFL
FAST ETHERNET INPUT/OUTPUT CONTROLLER
EN
and Table 21-2 for LEDs specific to the Gigabit
OL-2485-20