Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 407

Chapter 39 Connecting Cisco Analog Video Gateway Network Modules
Table 39-4
Pin
Terminal Block 0 (Lower)
1
2
3
4
5
6
7
8
9
10
Terminal Block 1 (Upper)
11
12
13
14
15
16
17
18
19
20
Connecting the EVM-IPVS-16A Network Module to the Network
This section describes how to connect the EVM-IPVS-16A network module to devices in the video
surveillance network.
If an installation technician has already connected the EVM-IPVS-16A to the devices in your network,
Note
then do not perform this task. Instead, proceed directly to the software configuration for your
EVM-IPVS-16A network module. See the Configuring the Analog Video Gateway for Integrated Service
Routers Cisco IOS feature module.
Prerequisites
•
OL-2485-20
EVM-IPVS-16A Terminal Block Pinouts
Type
RS-485 S0 +
RS-485 S0 –
In-Out A0 +
In-Out A0 –
In-Out A1 +
In-Out A1 –
In-Out A2 +
In-Out A2 –
In-Out A3 +
In-Out A3 –
RS-485 S1 +
RS-485 S1 –
In A4 +
In A4 –
In A5 +
In A5 –
In A6 +
In A6 –
In A7 +
In A7 –
Install the EVM-IPVS-16A network module in the router chassis. See the
Modules in Cisco Access
Guide.
How to Install, Connect, or Replace the EVM-IPVS-16A Network Module
Routers" chapter of the Cisco Network Modules Hardware Installation
Cisco Network Modules Hardware Installation Guide
"Installing Cisco Network
39-7