Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 402

Network modules installation guide
Table of Contents

Advertisement

Information About the EVM-IPVS-16A Network Module
Information About the EVM-IPVS-16A Network Module
Equipment connected to outdoor cameras must be permanently grounded in accordance with national
Warning
and local codes. Statement 374
Hazardous voltages may be present in the outdoor camera cables under fault conditions. Disconnect
Warning
all cables from the outdoor cameras before servicing this equipment. Statement 376
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security. Statement
1017
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
The compact flash module installed in the EVM-IPVS-16A network module is not field-replaceable.
Note
For software-related prerequisites and restrictions, see the Configuring the Analog Video Gateway for
Note
Integrated Service Routers Cisco IOS feature module.
For EVM-IPVS-16A network module features and benefits, supported hardware and software, and other
Note
product information, see the Cisco Analog Video Gateway Network Module (EVM-IPVS-16A) Data
Sheet.
Video Ports
16 video ports are provided, video ports 0 and 1 can be configured for input or output. The remaining 14
video ports can be configured for input only.
RS-485 Serial Communication Interfaces
The EVM-IPVS-16A network module supports a half-duplex, two-wire RS-485 communication
network, which sometimes is called a ring. The EIA/TIA RS-485 communications standard supports up
to 32 devices (driver/receiver pairs) on a cable of up to 4,000 feet. The EVM-IPVS-16A network module
has two RS-485 ports, supporting up to 64 devices. The EVM-IPVS-16A network module typically acts
as the master for each of the two RS-485 networks.
Cisco Network Modules Hardware Installation Guide
39-2
You need a router that supports the EVM-IPVS-16A network module. For a list of supported
platforms, see the Cisco Analog Video Gateway Network Module (EVM-IPVS-16A) Data Sheet.
Chapter 39
Connecting Cisco Analog Video Gateway Network Modules
OL-2485-20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents