Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 263

Connecting Cisco Intrusion Detection System
Network Modules
This chapter describes how to connect Cisco intrusion detection system (CIDS) network modules for
modular access routers and contains the following sections:
•
•
•
•
To determine whether your router supports a specific network module, see
Tip
CIDS Network Modules
This section provides information on the CIDS network module (NM-CIDS-K9) (see
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Caution
connect the CIDS network module (NM-CIDS-K9) only to intrabuilding or nonexposed wiring or
cabling. The intrabuilding cable must be shielded and the shield must be grounded at both ends.
Figure 22-1 Faceplate for the NM-CIDS-K9 Network Module
NM-CIDS-K9
OL-2485-20
CIDS Network Modules, page 22-1
CIDS Network Module LEDs, page 22-2
Online Insertion and Removal with a CIDS Network Module, page 22-3
Related Documents, page 22-4
DISK
Command & Control
LINK ACT
EN
PWR
FastEthernet 0
C H A P T E R
Cisco Network Modules Hardware Installation Guide
22
Table 1-6 on page 1-16.
Figure 22-1)
CF
22-1