Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 355

Chapter 33 Connecting Cisco IP VSAT Satellite WAN Network Modules
If an installation technician has already connected the NM-1VSAT-GILAT to the ODU, then do not
Note
perform this task. Instead, proceed directly to the
to the External Power Supply" section on page
Prerequisites
•
•
Steps
To connect the NM-1VSAT-GILAT network module to the ODU, follow these steps:
Disconnect the power supply from the ODU PWR connector on the NM-1VSAT-GILAT
Step 1
network module.
Make sure that the external power supply is disconnected from the NM-1VSAT-GILAT network module
Caution
before connecting cables to the RF-IN or RF-OUT connectors. If the external power supply is connected
to the ODU PWR connector while you connect or disconnect cables to the RF-IN or RF-OUT
connectors, you might short-circuit the NM-1VSAT-GILAT network module F connectors. This may
cause the network module to reset itself or lose data.
Take the indoor end of the cable that leads to the LNB, and connect it to the RF-IN connector on the
Step 2
NM-1VSAT-GILAT network module. (See
Take the indoor end of the cable that leads to the SSPA, and connect it to the RF-OUT connector on the
Step 3
NM-1VSAT-GILAT network module. (See
OL-2485-20
Install the NM-1VSAT-GILAT network module in the router chassis. See the
Network Modules in Cisco Access
Installation Guide.
Make sure that your ODU is installed and connected to RF cables that lead to the area near the
NM-1VSAT-GILAT network module. Contact your satellite service provider for ODU and cable
installation information.
How to Install, Connect, or Replace the NM-1VSAT-GILAT Network Module
"Connecting the NM-1VSAT-GILAT Network Module
33-12.
Routers" chapter of the Cisco Network Modules Hardware
Figure 33-5.)
Figure 33-5.)
Cisco Network Modules Hardware Installation Guide
"Installing Cisco
33-11