Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 245

Connecting Content Engine Network Modules for
Caching and Content Delivery
This chapter describes how to connect content engine (CE) network modules for caching and content
delivery and contains the following sections:
•
•
•
•
To determine whether your router supports a specific network module, see
Tip
CE Network Modules
This section provides overview information on CE network modules. The following CE network
modules are available on Cisco modular routers:
•
•
•
The 80-GB CE network module can run Application and Content Networking System (ACNS) software
or Cisco Wide Area File Services (WAFS) software. The 40-GB CE network module and the CE network
module with a SCSI controller can run ACNS software only. For information on configuring ACNS or
WAFS, see the documentation listed in the
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Caution
connect the CE network modules (NM-CE-BP-40G-K9 and NM-CE-BP-80G-K9) only to intrabuilding
or nonexposed wiring or cabling. The intrabuilding cable must be shielded and the shield must be
grounded at both ends.
OL-2485-20
CE Network Modules, page 19-1
CE Network Module LEDs, page 19-4
Online Insertion and Removal with a CE Network Module, page 19-5
Related Documents, page 19-7
CE network module with a 40-GB Disk Expansion Module (NM-CE-BP-40G-K9) (see
CE network module with a 80-GB Disk Expansion Module (NM-CE-BP-80G-K9) (see
CE network module with a SCSI Controller Expansion Module and a 68-pin SCSI connector for
connection to an external storage array (NM-CE-BP-SCSI-K9) (see
C H A P T E R
"Related Documents" section on page
Cisco Network Modules Hardware Installation Guide
19
Table 1-6 on page 1-16.
Figure 19-1)
Figure 19-1)
Figure 19-2)
19-7.
19-1