Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 366

Cisco NAC Network Modules
The Cisco NAC network module LEDs are shown in
Figure 34-1 NME-NAC-K9 Faceplate
Table 34-1 NME-NAC-K9 LED Descriptions
CF
LINK
ACT
DISK
PWR/SYS
EN
Cisco Network Modules Hardware Installation Guide
34-22
Chapter 34
NME-NAC-K9
Never remove compact
flash during operation
Status of the CompactFlash
Off—CompactFlash is not detected
Flashing—Application detected CompactFlash at bootup
Status of Gigabit Ethernet link
On—Link is enabled
Off—Link is disabled
Status of Gigabit Ethernet activity
On—Active
Off—Inactive
Status of hard drive activity
On—Active
Off—Inactive
Status of system shutdown
Do not remove power without first shutting down the application.
Note
See the "Shutting Down the NAC Network Module" section on
page 34-23.
On—Application is stable
Off—System is shut down and ready for host power down
Flashing—System shutdown is in progress
Status of the network module
On—Detected by the host Cisco IOS software and enabled
Off—Disabled
Connecting Cisco Network Admission Control Network Modules
Figure 34-1 and described in Table 34-1.
Shut down
!
application
before removing or
power cycling.
OL-2485-20