Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 281

Connecting Cisco Network Analysis Modules
This chapter describes how to connect Cisco network analysis modules for modular access routers and
contains the following sections:
•
•
•
The Network Analysis Module (NAM) is available in multiple hardware forms for some Cisco routers
Note
and Catalyst switches. This document applies only to the NAM for branch routers, also known as
modular access, multiservice, or integrated services routers.
To determine whether your router supports a specific network module, see
Tip
Network Analysis Module Overview
This section provides information on the network analysis module (NM-NAM). (See
All network modules have an enable (EN) LED. This LED indicates that the module has passed its
self-tests and is available to the router.
All network analysis modules display an additional power (PWR) LED, a disk (DISK) LED, and two
additional LEDs for the Fast Ethernet port (see
Caution To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
connect the network analysis module (NM-NAM) only to intrabuilding or nonexposed wiring or cabling.
The intrabuilding cable must be shielded and the shield must be grounded at both ends.
OL-2485-20
Network Analysis Module Overview, page 25-1
Online Insertion and Removal with a Cisco Network Analysis Module, page 25-3
Related Documents, page 25-4
C H A P T E R
Figure 25-1 and Table 25-1).
Cisco Network Modules Hardware Installation Guide
25
Table 1-6 on page 1-16.
Figure 25-1.)
25-1