Setting The Cpu Threshold Notification Types And Values - Cisco ME 3400 Software Configuration Manual

Configuring SNMP
The snmp-server host command specifies which hosts receive the notifications. The snmp-server
enable trap command globally enables the mechanism for the specified notification (for traps and
informs). To enable a host to receive an inform, you must configure an snmp-server host informs
command for the host and globally enable informs by using the snmp-server enable traps command.
To remove the specified host from receiving traps, use the no snmp-server host host global
configuration command. The no snmp-server host command with no keywords disables traps, but not
informs, to the host. To disable informs, use the no snmp-server host informs global configuration
command. To disable a specific trap type, use the no snmp-server enable traps notification-types global
configuration command.

Setting the CPU Threshold Notification Types and Values

Beginning in privileged EXEC mode, follow these steps to set the CPU threshold notification types and
values:
Command
Step 1 configure terminal
Step 2 process cpu threshold type {total | process
| interrupt} rising percentage interval
seconds [falling fall-percentage interval
seconds]
Step 3
end
Step 4 show running-config
Step 5 copy running-config startup-config
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
29-16
Purpose
Enter global configuration mode.
Set the CPU threshold notification types and values:
total—set the notification type to total CPU utilization.
•
• process—set the notification type to CPU process utilization.
• interrupt—set the notification type to CPU interrupt utilization.
• rising percentage—the percentage (1 to 100) of CPU resources
that, when exceeded for the configured interval, sends a CPU
threshold notification.
interval seconds—the duration of the CPU threshold violation in
•
seconds (5 to 86400) that, when met, sends a CPU threshold
notification.
falling fall-percentage—the percentage (1 to 100) of CPU
•
resources that, when usage falls below this level for the
configured interval, sends a CPU threshold notification.
This value must be equal to or less than the rising percentage
value. If not specified, the falling fall-percentage value is the
same as the rising percentage value.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 29 Configuring SNMP
OL-9639-07