Configuring A Host Statically To Join A Group - Cisco ME 3400 Software Configuration Manual

Configuring IGMP Snooping
Beginning in privileged EXEC mode, follow these steps to enable a static connection to a multicast
router:
Command
Step 1 configure terminal
Step 2
ip igmp snooping vlan vlan-id mrouter
interface interface-id
Step 3
end
Step 4 show ip igmp snooping mrouter [vlan vlan-id] Verify that IGMP snooping is enabled on the VLAN interface.
Step 5 copy running-config startup-config
To remove a multicast router port from the VLAN, use the no ip igmp snooping vlan vlan-id mrouter
interface interface-id global configuration command.
This example shows how to enable a static connection to a multicast router:
Switch# configure terminal
Switch(config)# ip igmp snooping vlan 200 mrouter interface gigabitethernet0/2
Switch(config)# end

Configuring a Host Statically to Join a Group

Hosts or Layer 2 ports normally join multicast groups dynamically, but you can also statically configure
a host on an interface.
Beginning in privileged EXEC mode, follow these steps to add a Layer 2 port as a member of a multicast
group:
Command
Step 1 configure terminal
Step 2
ip igmp snooping vlan vlan-id static ip_address
interface interface-id
Step 3
end
Step 4
show ip igmp snooping groups
Step 5 copy running-config startup-config
To remove the Layer 2 port from the multicast group, use the no ip igmp snooping vlan vlan-id static
mac-address interface interface-id global configuration command.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
21-8
Chapter 21
Purpose
Enter global configuration mode.
Specify the multicast router VLAN ID and the interface to the
multicast router.
The VLAN ID range is 1 to 1001 and 1006 to 4094.
•
• The interface can be a physical interface or a port channel.
The port-channel range is 1 to 48.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Statically configure a Layer 2 port as a member of a multicast
group:
vlan-id is the multicast group VLAN ID. The range is 1 to
•
1001 and 1006 to 4094.
ip-address is the group IP address.
•
interface-id is the member port. It can be a physical
•
interface or a port channel (1 to 48).
Return to privileged EXEC mode.
Verify the member port and the IP address.
(Optional) Save your entries in the configuration file.
Configuring IGMP Snooping and MVR
OL-9639-07