Creating And Modifying Vlans; Default Ethernet Vlan Configuration - Cisco ME 3400 Software Configuration Manual

Chapter 11 Configuring VLANs
isolated VLAN. In this case, isolation occurs between the UNI access port and the VLAN on the UNI
trunk port. Other access ports and other VLANs on the trunk port are isolated because they belong to
different VLANs.
UNIs, ENIs, and NNIs are always isolated from ports on different VLANs.

Creating and Modifying VLANs

You use VLAN configuration mode, accessed by entering the vlan global configuration command to
create VLANs and to modify some parameters. You use the interface configuration mode to define the
port membership mode and to add and remove ports from VLANs. The results of these commands are
written to the running-configuration file, and you can display the file by entering the show
running-config privileged EXEC command.
These sections contain VLAN configuration information:
•
•
•
•
•
•
If the switch is running the metro IP access or metro access image, for more efficient management of the
MAC address table space available on the switch, you can control which VLANs learn MAC addresses
by disabling MAC address learning on specific VLANs. See the
a VLAN" section on page 5-27

Default Ethernet VLAN Configuration

The switch supports only Ethernet interfaces.
VLANs.
On extended-range VLANs, you can change only the MTU size, the private VLAN, the remote SPAN,
Note
and the UNI-ENI VLAN configuration. All other characteristics must remain at the default conditions.
Table 11-2
Parameter
VLAN ID
VLAN name
OL-9639-07
Default Ethernet VLAN Configuration, page 11-7
VLAN Configuration Guidelines, page 11-8
Creating or Modifying an Ethernet VLAN, page 11-9
Assigning Static-Access Ports to a VLAN, page 11-11
Creating an Extended-Range VLAN with an Internal VLAN ID, page 11-11
Configuring UNI-ENI VLANs, page 11-12
Ethernet VLAN Defaults and Ranges
Default
1
VLANxxxx, where xxxx
represents four numeric digits
(including leading zeros) equal
to the VLAN ID number
for more information.
Table 11-2 shows the default configuration for Ethernet
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Creating and Modifying VLANs
"Disabling MAC Address Learning on
Range
1 to 4094.
Extended-range VLANs (VLAN
Note
IDs 1006 to 4094) are not saved in
the VLAN database.
No range
11-7