Dhcp For Ipv6 Address Assignment; Static Routes For Ipv6; Rip For Ipv6; Ospf For Ipv6 - Cisco ME 3400 Software Configuration Manual

Understanding IPv6
•
For more information about IPv4 and IPv6 protocol stacks, see the "Implementing IPv6 Addressing and
Basic Connectivity" chapter of Cisco IOS IPv6 Configuration Library on Cisco.com.

DHCP for IPv6 Address Assignment

DHCPv6 enables DHCP servers to pass configuration parameters, such as IPv6 network addresses, to
IPv6 clients. The address assignment feature manages nonduplicate address assignment in the correct
prefix based on the network where the host is connected. Assigned addresses can be from one or multiple
prefix pools. Additional options, such as default domain and DNS name-server address, can be passed
back to the client. Address pools can be assigned for use on a specific interface, on multiple interfaces,
or the server can automatically find the appropriate pool.
This document describes only the DHCPv6 address assignment. For more information about configuring
the DHCPv6 client, server, or relay agent functions, see the "Implementing DHCP for IPv6" chapter in
the Cisco IOS IPv6 Configuration Library on Cisco.com.

Static Routes for IPv6

Static routes are manually configured and define an explicit route between two networking devices.
Static routes are useful for smaller networks with only one path to an outside network or to provide
security for certain types of traffic in a larger network.
For more information about static routes, see the "Implementing Static Routes for IPv6" chapter in the
Cisco IOS IPv6 Configuration Library on Cisco.com.

RIP for IPv6

Routing Information Protocol (RIP) for IPv6 is a distance-vector protocol that uses hop count as a
routing metric. It includes support for IPv6 addresses and prefixes and the all-RIP-routers multicast
group address FF02::9 as the destination address for RIP update messages.
For more information about RIP for IPv6, see the "Implementing RIP for IPv6" chapter in the Cisco IOS
IPv6 Configuration Library on Cisco.com.

OSPF for IPv6

The switch supports Open Shortest Path First (OSPF) for IPv6, a link-state protocol for IP. For more
information, see the "Implementing OSFP for IPv6" chapter in the Cisco IOS IPv6 Configuration
Library on Cisco.com.

EIGRP IPv6

The switch supports Enhanced Interior Gateway Routing Protocol (EIGRP) for IPv6. It is configured on
the interfaces on which it runs and does not require a global IPv6 address.
Before running, an instance of EIGRP IPv6 requires an implicit or explicit router ID. An implicit router
ID is derived from a local IPv4 address, so any IPv4 node always has an available router ID. However,
EIGRP IPv6 might be running in a network with only IPv6 nodes and therefore might not have an
available IPv4 router ID.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
36-6
If you do not plan to use IPv6, do not use the dual stack template because it results in less hardware
memory availability for each resource.
Chapter 36 Configuring IPv6 Unicast Routing
OL-9639-07