Cisco ME 3400 Software Configuration Manual page 562

Configuring SNMP
Though visible in the command-line help strings, the flash insertion, flash removal, fru-ctrl, and vtp
Note
keywords are not supported. The snmp-server enable informs global configuration command is not
supported. To enable the sending of SNMP inform notifications, use the snmp-server enable traps
global configuration command combined with the snmp-server host host-addr informs global
configuration command.
You can use the snmp-server host global configuration command to a specific host to receive the
notification types listed in
Beginning in privileged EXEC mode, follow these steps to configure the switch to send traps or informs
to a host:
Command
Step 1
configure terminal
Step 2
snmp-server engineID remote
ip-address engineid-string
Step 3 snmp-server user username
groupname {remote host [udp-port
port]} {v1 [access access-list] | v2c
[access access-list] | v3 [encrypted]
[access access-list] [auth {md5 | sha}
auth-password]}
Step 4 snmp-server group groupname {v1 |
v2c | v3 {auth | noauth | priv}} [read
readview] [write writeview] [notify
notifyview] [access access-list]
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
29-14
Table 29-5.
Purpose
Enter global configuration mode.
Specify the engine ID for the remote host.
Configure an SNMP user to be associated with the remote host created in
Step 2.
You cannot configure a remote user for an address without first
Note
configuring the engine ID for the remote host. Otherwise, you
receive an error message, and the command is not executed.
Configure an SNMP group.
Chapter 29 Configuring SNMP
OL-9639-07