Configuring Mvr; Default Mvr Configuration; Mvr Configuration Guidelines And Limitations - Cisco ME 3400 Software Configuration Manual

Ethernet access switch
Hide thumbs Also See for ME 3400:
Table of Contents

Advertisement

Configuring MVR

These messages dynamically register for streams of multicast traffic in the multicast VLAN on the
Layer 3 device. Switch B. The access layer switch, Switch A, modifies the forwarding behavior to allow
the traffic to be forwarded from the multicast VLAN to the subscriber port in a different VLAN,
selectively allowing traffic to cross between two VLANs.
IGMP reports are sent to the same IP multicast group address as the multicast data. The Switch A CPU
must capture all IGMP join and leave messages from receiver ports and forward them to the multicast
VLAN of the source (uplink) port, based on the MVR mode.
Configuring MVR

Default MVR Configuration

Table 21-5
Table 21-5
Feature
MVR
Multicast addresses
Query response time
Multicast VLAN
Mode
Interface (per port) default
Immediate Leave

MVR Configuration Guidelines and Limitations

Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
21-18
Default MVR Configuration, page 21-18
MVR Configuration Guidelines and Limitations, page 21-18
Configuring MVR Global Parameters, page 21-19
Configuring MVR on Access Ports, page 21-20
Configuring MVR on Trunk Ports, page 21-22
shows the default MVR configuration.
Default MVR Configuration
Receiver ports on a switch can be in different VLANs, but they should not belong to the multicast
VLAN.
Trunk ports or access ports can be configured as receiver ports.
The maximum number of multicast entries (MVR group addresses) that can be configured on a
switch (that is, the maximum number of television channels that can be received) is 512.
MVR multicast data received in the source VLAN and leaving from receiver ports has its
time-to-live (TTL) decremented by 1 in the switch.
Chapter 21
Default Setting
Disabled globally and per interface
None configured
0.5 second
VLAN 1
Compatible
Neither a receiver nor a source port
Disabled on all ports
Configuring IGMP Snooping and MVR
OL-9639-07

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents