Dhcpv6 Address Assignment Configuration Guidelines; Enabling The Dhcpv6 Server Function - Cisco ME 3400 Software Configuration Manual

Configuring IPv6

DHCPv6 Address Assignment Configuration Guidelines

When configuring a DHCPv6 address assignment, consider these guidelines:
•
•
•

Enabling the DHCPv6 Server Function

Beginning in privileged EXEC mode, follow these steps to enable the DHCPv6 server function on an
interface.
Command
Step 1
configure terminal
Step 2 ipv6 dhcp pool poolname
Step 3 address prefix IPv6-prefix lifetime {t1 t1 | infinite} (Optional) Specify an address prefix for address assignment.
Step 4
link-address IPv6-prefix
Step 5 vendor-specific vendor-id
Step 6 suboption number {address IPv6-address | ascii
ASCII-string | hex hex-string}
Step 7 exit
Step 8 exit
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
36-14
In the procedures, the specified interface must be one of these Layer 3 interfaces:
DHCPv6 IPv6 routing must be enabled on a Layer 3 interface.
–
SVI: a VLAN interface created by using the interface vlan vlan_id command.
–
– EtherChannel port channel in Layer 3 mode: a port-channel logical interface created by using
the interface port-channel port-channel-number command.
Before configuring DHCPv6, you must select a Switch Database Management (SDM) template that
supports IPv4 and IPv6.
The switch can act as a DHCPv6 client, server, or relay agent. The DHCPv6 client, server, and relay
function are mutually exclusive on an interface.
Chapter 36
Purpose
Enter global configuration mode.
Enter DHCP pool configuration mode, and define the name
for the IPv6 DHCP pool. The pool name can be a symbolic
string (such as Engineering) or an integer (such as 0).
This address must be in hexadecimal, using 16-bit values
between colons.
lifetime t1 t1—Specify a time interval (in seconds) that an
IPv6 address prefix remains in the valid state. The range is 5
to 4294967295 seconds. Specify infinite for no time interval.
(Optional) Specify a link-address IPv6 prefix.
When an address on the incoming interface or a link-address
in the packet matches the specified IPv6 prefix, the server
uses the configuration information pool.
This address must be in hexadecimal, using 16-bit values
between colons.
(Optional) Enter vendor-specific configuration mode, and
enter a vendor-specific identification number. This number is
the vendor IANA Private Enterprise Number. The range is 1
to 4294967295.
(Optional) Enter a vendor-specific suboption number. The
range is 1 to 65535. Enter an IPv6 address, ASCII text, or a
hex string as defined by the suboption parameters.
Return to DHCP pool configuration mode.
Return to global configuration mode.
Configuring IPv6 Unicast Routing
OL-9639-07