Monitoring Private Vlans - Cisco ME 3400 Software Configuration Manual

Monitoring Private VLANs

•
This example shows how to map the interfaces of VLANs 501 and 502 to primary VLAN 10, which
permits routing of secondary VLAN incoming traffic from private VLANs 501 to 502:
Switch# configure terminal
Switch(config)# interface vlan 10
Switch(config-if)# private-vlan mapping 501-502
Switch(config-if)# end
Switch# show interfaces private-vlan mapping
Interface Secondary VLAN Type
--------- -------------- -----------------
vlan10
vlan10
Monitoring Private VLANs
Table 12-1
Table 12-1
Command
show interfaces status
show vlan private-vlan
[type]
show interface switchport
show interface
private-vlan mapping
This is an example of the output from the show vlan private-vlan command:
Switch(config)# show vlan private-vlan
Primary Secondary Type
------- --------- ----------------- ------------------------------------------
10
10
10
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
12-14
Use the remove keyword with a secondary_vlan_list to clear the mapping between secondary
VLANs and the primary VLAN.
501 isolated
502 community
shows the privileged EXEC commands for monitoring private-VLAN activity.
Private VLAN Monitoring Commands
501 isolated
502 community
503 non-operational
Purpose
Displays the status of interfaces, including the VLANs to which they
belong.
Display the private-VLAN information for the switch.
Display the private-VLAN configuration on interfaces.
Display information about the private-VLAN mapping for VLAN
interfaces.
Ports
Fa0/1, Gi0/1, Gi0/2
Fa0/11, Fa0/12, Gi0/1
Chapter 12 Configuring Private VLANs
OL-9639-07