Cisco ME 3400 Software Configuration Manual page 712

Configuring EtherChannels
Beginning in privileged EXEC mode, follow these steps to assign a Layer 2 Ethernet port to a Layer 2
EtherChannel. This procedure is required.
Command
Step 1 configure terminal
Step 2
interface interface-id
Step 3 no shutdown
Step 4 switchport mode {access | trunk}
switchport access vlan vlan-id
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
34-12
Chapter 34 Configuring EtherChannels and Link-State Tracking
Purpose
Enter global configuration mode.
Specify a physical port, and enter interface configuration mode.
Valid interfaces include physical ports.
For a PAgP EtherChannel, you can configure up to eight ports of
the same type and speed for the same group.
For a LACP EtherChannel, you can configure up to 16 Ethernet
ports of the same type. Up to eight ports can be active, and up to
eight ports can be in standby mode.
If the interface is a UNI, you must enter the port-type
Note
{eni | nni} interface configuration command before
configuring PAgP or LACP.
Enable the port, if necessary. By default, UNIs and ENIs are
disabled, and NNIs are enabled.
Assign all ports as static-access ports in the same VLAN, or
configure them as trunks.
If you configure the port as a static-access port, assign it to only
one VLAN. The range is 1 to 4094.
OL-9639-07