Displaying The Sdm Templates - Cisco ME 3400 Software Configuration Manual

Chapter 6 Configuring SDM Templates
This is an example of an output display when you have changed the template to the layer-2 template and
have not reloaded the switch:
Switch# show sdm prefer
The current template is "default" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses:
number of IPv4 IGMP groups + multicast routes:
number of IPv4 unicast routes:
number of IPv4 policy based routing aces:
number of IPv4/MAC qos aces:
number of IPv4/MAC security aces:
On next reload, template will be "layer-2" template.
To return to the default template, use the no sdm prefer global configuration command.
This example shows how to configure a switch with the layer-2 template.
Switch(config)# sdm prefer layer-2
Switch(config)# end
Switch# reload
Proceed with reload? [confirm]

Displaying the SDM Templates

Use the show sdm prefer privileged EXEC command with no parameters to display the active template.
Use the show sdm prefer [default | dual-ipv4-and-ipv6 {default | routing | vlan} | layer-2] privileged
EXEC command to display the resource numbers supported by the specified template.
This is an example of output from the show sdm prefer command, displaying the template in use:
Switch# show sdm prefer
The current template is "default" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses:
number of IPv4 IGMP groups + multicast routes:
number of IPv4 unicast routes:
number of IPv4 policy based routing aces:
number of IPv4/MAC qos aces:
number of IPv4/MAC security aces:
OL-9639-07
number of directly-connected IPv4 hosts:
number of indirect IPv4 routes:
number of directly-connected IPv4 hosts:
number of indirect IPv4 routes:
5K
1K
9K
5K
4K
0.5K
0.5K
1K
5K
1K
9K
5K
4K
0.5K
0.5K
1K
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Displaying the SDM Templates
6-5