Displaying Ethernet Cfm Information - Cisco ME 3400 Software Configuration Manual

Chapter 41 Configuring Ethernet OAM, CFM, and E-LMI
Command
Step 11
ip sla schedule operation-number [ageout seconds]
[life {forever | seconds}] [recurring] [start-time
{hh:mm {:ss} [month day | day month] | pending |
now | after hh:mm:ss}]
Step 12 end
Step 13 show ip sla configuration [operation-number]
Step 14
copy running-config startup-config
To remove an IP SLAs operation, enter the no ip sla operation-number global configuration command.

Displaying Ethernet CFM Information

You can use the privileged EXEC commands in
Table 41-1 Displaying CFM Information
Command
show ethernet cfm domain brief
show ethernet cfm errors
show ethernet cfm maintenance-points local
show ethernet cfm maintenance-points remote
[detail | domain | level]
OL-9639-07
Purpose
Schedule the time parameters for the IP SLAs operation.
• operation-number—Enter the IP SLAs operation
number.
• (Optional) ageout seconds—Enter the number of
seconds to keep the operation in memory when it is not
actively collecting information. The range is 0 to
2073600 seconds. The default is 0 seconds.
(Optional) life—Set the operation to run indefinitely
•
(forever) or for a specific number of seconds. The
range is from 0 to 2147483647. The default is 3600
seconds (1 hour)
• (Optional) recurring—Set the probe to be
automatically scheduled every day.
(Optional) start-time—Enter the time for the
•
operation to begin collecting information:
To start at a specific time, enter the hour, minute,
–
second (in 24-hour notation), and day of the
month.
Enter pending to select no information collection
–
until a start time is selected.
Enter now to start the operation immediately.
–
Enter after hh:mm:ss to show that the operation
–
should start after the entered time has elapsed.
Return to privileged EXEC mode.
Show the configured IP SLAs operation.
(Optional) Save your entries in the configuration file.
Table 41-1
Purpose
Displays brief details about CFM maintenance domains.
Displays CFM continuity check error conditions logged on a device since
it was last reset or since the log was last cleared. When CFM crosscheck is
enabled, displays the results of the CFM crosscheck operation.
Displays maintenance points configured on a device.
Displays information about a remote maintenance point domains or levels or
details in the CFM database.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Displaying Ethernet CFM Information
to display Ethernet CFM information.
41-13