Cisco ME 3400 Software Configuration Manual page 625

Chapter 32 Configuring Control-Plane Security
Monitoring Control-Plane Security
You can monitor control-plane security settings and statistics on the switch or on an interface, and you
can clear these statistics at any time by using the privileged EXEC commands in
information about the commands, see the command reference for this release.
Table 32-2 Commands for Monitoring Control-Plane Security
Command
clear policer cpu uni-eni counters
{classification | drop}
debug platform policer cpu uni-eni
show platform policer cpu {classification |
interface interface-id}
show policer cpu uni-eni {drop [interface
interface-id] | rate}
OL-9639-07
Purpose
Clear all control-plane statistics per feature (classification) or all statistics
maintained by the control-plane policer (drop).
Enable debugging of the control-plane policer. This command displays
information messages when any changes are made to CPU protection.
Display control-plane policer information.
• classification—show classification statistics.
interface interface-id—show policer indexes for the specified
•
interface.
Display CPU policer information for the switch.
drop [interface interface-id] —show the number of dropped frames for
•
all interfaces or the specified interface.
• rate—show the configured threshold rate for CPU policers.
If CPU protection is disabled, this message appears in the output:
Switch# show policer cpu uni drop
CPU Protection feature is not enabled
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Monitoring Control-Plane Security
Table 32-2. For more
32-7